Modal 1

Dash Business Phone System Interface

Backed by 24/7 Support

No matter the time, no matter your location, our team backs your business communications around the clock with free support so you can focus on – well – business.

Yealink W60P: Basic Use and Resetting

Review this guide on how to set your Yealink W60P to its default settings.

  1. Factory Reset for Yealink W60P
  2. Register Handset to Base
  3. Assign a Line to Your Handset(s)

Factory Reset for Yealink W60P

  1. Power off the unit. If the unit is powered by PoE, this might mean unplugging the network cable.
  2. Wait 15 seconds.
  3. Press and hold the connect button on the base station.
  4. Reconnect the power.
  5. Wait until all 3 status lights are on, showing solid green.
  6. Release the button and wait 5 minutes.
  7. Power off the unit.
  8. Wait 15 seconds.
  9. Reconnect the power.
  10. Your phone may update its configuration after the reboot which may result in a second reboot process automatically within a minute or two of the first reboot.


Register Handset to Base

  1. When the handset LCD screen prompts “Press base paging 2s then press Reg.”, long-press the Wireless button User-added image on the base station until the registration LED flashes.
  2. Press the OK soft key on the handset.
  3. Select Register Handset.
  4. Select the desired base and then press the OK soft key. The handset begins searching the base.
  5. Press the OK soft key after searching a base successfully.
  6. Enter the base PIN (default: 0000), and then press the Done soft key to complete registration.
    • NOTE: You can also press the OK key to enter the main menu, and then select Settings, then Registration, then Register Handset and repeat steps 2-4 to register multiple base stations.
  7. After the success of registration, the handset LCD screen prompts “Handset Subscribed” and “Base NO. (The last 4 characters of connected Base’s MAC address)”. If the handset LCD screen prompts “Searching for Base”, please check if your base station is powered on.


Assign a Line to Your Handset(s)

  1. Navigate to Account > Handset Name. Name each handset what you would like to see displayed on handset. Name, ext number or something else. Click “Confirm” to save.
  2. Navigate to Account > Number Assignment. This is where you determine which handset can answer which lines when taking and making calls. Right now ext 815 will ring only handset 1. You can have it ring others or different ones based on the checkboxes selected above. Click “Confirm” when the changes are made.
  3. Navigate to Phone > Preference and make sure the following are set correctly:
    • Time Server: pool.ntp.org
    • Time Zone: Select local time zone
    • Daylight Savings Time: Automatic
    • Click “Confirm” to save